License Plate Adaptor Kit

As i said in the title, this actually works fine and looks good. There's a nice finish on the bars themselves my issue is with either the length of the bolts or maybe it should include some rubber washers or something. Or maybe i'm missing something on install?

When you mount the bar and screw the top bolts in place, if you tighten the bolts all of the way so that the bar is 100% secured, when you put your USDM plate on the bar and tighten the plate into the bar, you can only tighten the bolt about halfway down so as a result the plate has like 10mm where it just shakes between the bar and the bolt. This is because the bolts are all the same length, so since the bar is now secured against the body, the bolts that screw in the plate can only be tightened enough to be flush with the back side of the bar before it hits the body of the car.

This kit should either include shorter bolts to mount the plate to the bar so that the tip of the bolt could never thread further than the back of of the bar, or washers (preferably rubber if they are intended on being placed between the bar and the car) to space out either the bar from the car, the plate from the bar, or the bolt head from the plate.

A simple addition/modification like that would make this an excellent product as opposed to merely functional, i'm likely just going to run to the hardware store, but that's pretty annoying..

I can't stand crooked, zip tied license plates. These brackets fit perfect, and were an easy 5 minute install. The purchase was well worth it.

This product was the first item I purchased when I brought my R32 GTR to the United States. I could not handle the bent license plate. This adapter works perfectly and is very high quality. My only complaint is the price, with shipping it ended up being $52 to the US, which is a lot for my license plate to be straight.